MER6765BAW Range Parts List

Anti-tip bracket

Sold individually.

Door hinge - left or right side (hinge)

Sold individually.

Screw

Sold Individually.

Screw

Sold individually.

Round snap nut - black (nut, snap (round-blk))

Oven light (light, oven asy.)

The oven light provides light in the oven cavity. The light assembly is a little over four inches long and has a 660-watt light bulb. If the light is not turning on, the bulb may be burnt out or the socket has failed and will need to be replaced. This is a genuine OEM part.

Stand mixer screw (sub 7101p112-60)

This screw is sold individually.

Door glass bottom support - white (support, glass (wht))

This part helps support the oven glass.

Dual surface burner switch (switch, element (dual))

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.

Indicator light lens (lens, indicator light)

Sold individually.

Insulation (range oven insulation)

Oven Wrap Insulation.

Exterior oven door glass - white (kit, door (w/tape-wht))

This is just the outer glass - it is not the complete door assembly.

Indicator light (light, indicator)

Electronic control board (control, h3 (elec))

This part is known as the "brains" of the appliance.

Nut- snap (sub 7103p114-60)