MER6772BAS Range Parts List

Terminal block (block, terminal)

The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.

Infinite switch - 6 inch (switch, infinite (6 element))

Elmnt-surf (sub 12002142)

Screw (screw (8abx3/8-blk))

Oven rack (rack, oven (upr))

Sold individually.

Anti-tip bracket

Sold individually.

Elmnt-surf

Screw (sub 7101p040-60)

Sold Individually.

Screw

Sold individually.

Round snap nut - black (nut, snap (round-blk))

Halogen light bulb

This part is the replacement halogen light bulb for your range. The bulb is 10 watts and 12 volts. The halogen lamp lights up the inside of the oven you can see the cooktop more effectively in darkness. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range hood before you begin this repair. This bulb is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Stand mixer screw (sub 7101p112-60)

This screw is sold individually.

Door hinge - left or right side (hinge, oven door)

This hinge can be used for either the left or the right side of the oven door. Sold individually.

Frame screw (sub 7101p126-60)

Sold Individually.

Dual surface burner switch (switch, element (dual))

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.