MMV1153AAW Parts List

Switch,micro

This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.

Filter (filter,(mech) aharcaa)

Sold individually.

Screw,tapping

Grille vent (grille, vent (wht))

This grille vent mounts on the top of the microwave above the door. This is just the grille vent.

Wave guide rivet (rivet, plastic)

This rivet is used for the stirrer cover/wave guide. They are sold individually.

Black sleeve diode (diode)

The black sleeve microwave diode is used as an electrical current control device inside the appliance. It will allow power to go one way but not the other. If your microwave is not heating properly you may need to replace this part. Please remember to disconnect power to the microwave before starting the repair. This is a genuine OEM part.

Door interlock switch kit (sub 56001100)

The door interlock switch kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16-inch terminals. The switches are used to sense when the microwave door is open or closed. If your microwave will not start, or will not turn on, you may need to replace these switches. This is a genuine OEM kit. Please remember to disconnect the power to your microwave before starting the repair. PLEASE NOTE: The door interlock switch kit includes 2 single pole, double throw (SPDT) micro switches. As per the manufacture for the secondary interlock switch order part # 56001100.

Turntable motor coupler

The turntable motor coupler connects the turntable motor to the tray. If the turntable on your microwave will not rotate, you may have a faulty motor coupler. The coupler commonly has a D shaped opening that fits tightly onto the motor shaft. If it is cracked, or worn it will need to be replaced. This is a genuine OEM replacement part sourced directly from the manufacturer.

Plate,mount

Cover,stirrer fan

High voltage diode

Rivet

Magnetron

Adapter - exhaust (adapter, exhaust)

Holder assembly,locker