REP303A1W Gibson Range Parts List

Terminal block kit (stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective t)

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or is not heating properly, it is likely an issue with the terminal block and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Bake element - 240v (oven bake heating element with push-on wire terminals. If the oven won't heat, the bake element may have burned out. Often, if the bake element has bu)

This heating element is a partially open-style bake element. Carrying 240V and 2000W, it is 19-1/4" wide by 15" long. The two 90-degree push-on male spade terminals are 13-3/4" apart.

Surface element - 8 inch - 220v (stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to d)

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil to see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Surface element - 6 inch (range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective.)

The standard Y-frame 6” surface element supplies heat to the cooking surface on your range and is a genuine OEM part. It has a black center medallion and looped terminal end. If your element is not heating, shorted out around the coil or if the terminal block shorted out and burnt out the contacts on the end, you may need to replace the element. Please be sure to disconnect the power to your range before starting your repair. Note: The manufacturer suggests replacing the receptacle at the same time.

Main terminal block kit (terminal block kit for electric range and dryer power cords.)

This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

2 pack light bulb - 40w

Trim ring - 8" (surface burner trim ring for large (8") burner)

Trim ring - 6" (surface burner trim ring for small (6") burner)

Gasket (oven door gasket/seal)

This oven door gasket prevents heat from escaping the oven cavity when in use.

Hinge (hinge arm, oven door)

Spring-oven door

4 wire cord - 4ft - 50amp (electric range power cord kit, 4 foot 50 amp 4 wire with closed eyelets and strain relief)

4`-3 wire 40amp ran (electric range power cord kit, 4 foot 40 amp 3 wire w/open eyelets & strain relief)

Porcelain drip pan - small (porcelain surface burner drip pan, small burner)

6'rng50a4s cs6 cord (range power cord. 6 foot 50 amp 4 wire with closed eyelets and strain relief)