RSD20A-BM05A Parts List

Screw

Sold individually.

Rivet (plastic rivet)

This part is the replacement rivet for your refrigerator. It is made of black plastic and is a little less than an inch long and about ¼ inch wide. It is an authentic OEM part sourced directly from the manufacturer, and it is sold individually.

Compression nut (nut, 1/4" plastic water line)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Tray (ice cube making tray)

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

Defrost thermostat (defrost thermostat with wires, l40-25)

This refrigerator defrost thermostat will cut out at 40 degrees Fahrenheit and kick back when the temperature drops to 25 degrees Fahrenheit.

Crisper drawer shelf support

This crisper drawer shelf support is used for many refrigerators. It is all white in color and is made entirely of plastic. This shelf support is less than an inch long.

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Front pick-off shelf (front- pic)

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Screw - 6-32 x 5/16 (screw, 6-32 x 5/16)

This screw is well under an inch long, and is made of metal.

Ice maker front cover (ice maker module front cover)

Defrost evaporator pan (water collection and evaporation pan)

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Water hose clamp (clamp)

These tube clamps are sold individually. The screw is not included.