TBF18ZWB Hotpoint Refrigerator Parts List

Ice cube tray

14 Cube.

Evaporator fan blade kit (fan blade, plastic)

Condenser fan motor (condenser fan motor kit, ¼” spade terminal connection. *note: If original motor has a wire harness connection see related item below.)

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

Door handle

This handle attaches to the door to allow you to open the door. This handle is the inner part of the handle.

Defrost thermostat kit (defrost thermostat kit with wires, l45-20, brackets, and crimp-style wire connectors)

This defrost thermostat kit comes with the installation with wires, mounting brackets, and wire connectors. L45-20.

Defrost timer (defrost timer assembly. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, but its terminals are bent and the leads are external.

Heat probe

Single water valve (water inlet valve for round cube icemaker, with gasket)

This single outlet valve comes with a gasket and is intended for refrigerators that have ice makers which make round ice cubes. The water inlet valve will release water from the supply line into the ice mold and from the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. This water inlet valve is a genuine OEM part. Remember to disconnect the power and water supply to your refrigerator before beginning this repair.

Front wheel

Bucket utility (utility bucket)

Evaporator fan motor (evaporator (freezer) fan motor assembly)

This evaporator fan motor operates in a counter clockwise fashion. This motor's stack is 3/8 of an inch, and the motor has two terminals: one on the right side, and one on the left side. Use this evaporator fan motor for your GE brand refrigerator.

Ice maker seal kit (ice maker push kit with new shaft, seal and screw. *washer removal and seal install tools no longer available from GE)

This newly redesigned icemaker seal kit is used to rebuild the ice maker cube ejector. The kit comes with a new shaft, seal, and screw. General Electric no longer carries the washer removal and seal install tools. This seal kit is a genuine OEM part.

Temperature control thermostat (thermostat assembly)

This part maintains the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process.

"shelf front white 27.34"" (front shelf trim, white)

Comp. Repl. Kit r-12 (replacement compressor kit)