TBF22RCC GE Refrigerator Parts List

Light switch (switch light)

The refrigerator light switch turns the interior light off and on when you open or close the refrigerator door. The light switch also prevents the front dispenser from working if the refrigerator door is opened. If the switch has shorted out or the light bulb is not turning on when the door is open, you may need to replace the switch. This switch is white in color and measures approximately 1 1/2” L x 1 1/4” W. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting the repair.

Push on nut (nut push on)

This push on nut is for your dishwasher or refrigerator. As the name suggests, it pushes into place, rather than being screwed in. It is approximately half an inch in diameter and is made of stainless steel.

Defrost timer - 120v 60hz (defrost control)

The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. This 120V 60Hz defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange. If your refrigerator is too warm, freezer section is too warm, freezer is not defrosting, or leaking, you may need to replace the defrost timer. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Package of 12 screws (scr 8-18 ab rndw 5/8 ss)

This is a package of twelve Phillips-head screws. They can be used as replacement screws in refrigerators, ice makers, or freezers. Be sure to check that your appliance model is compatible with these screws. The screws are approximately ¾ of an inch in length.

Ice dispensing drive cup (cup drive dispenser)

Found at the end of the auger in the ice container - replace when the icemaker doesn't dispense ice.

Ice dispenser solenoid service kit (solenoid & armature)

This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.

Ice bucket auger (auger helix dispenser)

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

Armature kit (shroud solenoid)

Evaporator fan blade kit (ring compression)

Defrost timer (defrost timer. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

Condenser fan motor (motor cond fan)

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

Evaporator fan motor kit (motor evap fan)

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

Screw (scr 12-24 ahxw 7/8 spp)

Comes 12 in a pack.

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

1/4 tubing nut (nut for 1/4" plastic tubing)