UAN8305-82A Parts List

Rear drum bearing kit (dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate.)

This rear drum bearing kit includes one bearing, one ball shaft, one ball bearing, one ball bearing retainer, a small tube of high temperature lubricant, and installation screws. The support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. Over time the drum bearing will wear out. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Drum support bearing (rear bearing support for dryer drum.)

The rear drum support bearing helps support the dryer drum to rotate quietly and smoothly during operation. The bearing attaches on the inside of the rear panel of the dryer cabinet. If your dryer is making unusual noises or will not tumble, you may need to replace this part. It is white in color and made of plastic. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

M series ignition coil kit (dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils ma)

The gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If it takes too long to dry or there is no heat, the coils may be bad and will need to be replaced. When the coils go bad they will not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Flat style belt (dryer drum drive belt. 87 3/4 inches long and 1/2 inch wide. This drive belt wraps all the way around the dryer drum, around a tension pulley, and the)

This is a flat style ridgeless dryer belt.

Idler pulley assembly (idler tension pulley with bracket for dryer drum belt)

The idler pulley assembly provides the tension required for a flat belt. It also serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel. If your dryer is noisy or will not tumble you may need to replace the idler pulley. This is a genuine OEM part.

Door latch kit (dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.)

This door latch kit comes with the strike and the catch.

Flame sensor (flame sensor for gas dryer)

This part senses the flame for heat allowing the gas valve to open.

Igniter (gas dryer igniter)

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.

High temperature adhesive (high temperature adhesive for installing rubber and felt seals)

The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.

Glide n' guard

Rotary knob - chrome (timer knob, chrome)

Sold individually.

Lint screen and frame kit (lint filter with frame and screws)

This dryer lint screen and frame is used for Frigidaire/WCI brand electric and gas dryers. The filter is 14-1/4 inches wide and comes with a bezel frame and mounting screws.

Door switch (push button door switch)

Elbow (4 inch 90 degree vent elbow)

5ft ucvent (universal connect flexable vent. 4" diameter extends to five feet.)