UFP16DL Freezer Parts List

Freezer door key (key)

This white plastic freezer door key is used for most upright or chest freezers. If your door key becomes broken or lost it will need to be replaced. This is a genuine OEM part. It is sold individually.

Defrost timer (timer, defrost)

The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, the freezer section is too warm, or the freezer is not defrosting, you might need to replace the defrost timer. This defrost timer is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Door shelf end cap set - left and right side (insert, shelf front, narrow, lh (sold individually, 4 recommended))

This refrigerator door shelf end cap kit is to help support the retainer bar in place on the door. The kit includes both the left and right-side end caps. The end caps are white in color and made of plastic. This is a genuine OEM part.

Defrost thermostat (thermostat, defrost limiter)

The defrost thermostat snaps onto the top portion of the evaporator. It acts as a safety device and protects the evaporator from overheating during the defrost cycle. The thermostat can sense the rise in the evaporator temperature during the defrost cycle and cycles the defrost heater off after all the frost is melted from the coils. This limiter thermostat will cut out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fahrenheit. The defrost thermostat may need to be replaced if the appliance is experiencing temperature-related issues. This is a genuine OEM part. It is recommended to disconnect the power to your appliance before starting your repair.

Gasket retainer clip kit - 24 pieces (clip panel retaining (38))

These are used to hold your gasket in place.

Screw (screws)

Sold individually.

Door gasket (seal, freezer door)

This gasket is intended for use with upright freezers. This white door gasket is used to make an air-tight seal for the cabinet when the door is closed

Shelf support - right side (peg, r. Front (sold individually, 3 recommended))

The shelf support is used to support the right side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf to be uneven and the shelf support will need to be replaced. The support is white in color, measures approximately 1 1/2”, and is made of plastic. This is the right side support only. Left support is not included, must be ordered separately. This is a genuine OEM part and is sold individually.

Levelling leg (leg (sold individually, 4 recommended))

Sold individually.

Door gasket (seal, freezer door)

This white door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Shelf support - left side (peg, l. Front (sold individually, 3 recommended))

The shelf support is used to support the left side of the shelf in the freezer section of your refrigerator. If the shelf support breaks it can cause the shelf not to sit even and the shelf support will need to be replaced. The support is white in color and made of plastic. This is a genuine OEM part and so individually. Note: This is just the left side support. Right support is not included, must be ordered separately.

Screw

Sold Individually.

Filter - drier (drier)

Refrigerant system filter/dryer.

Fan motor kit (use 216690400)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Bearing-hinge (bearing, hinge, lower)