UMV1152BAB Parts List

Switch,micro

This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.

Filter (filter,(mech) aharcaa)

Sold individually.

Screw,tapping

Door interlock switch kit (switch, micro)

The door interlock switch kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16-inch terminals. The switches are used to sense when the microwave door is open or closed. If your microwave will not start, or will not turn on, you may need to replace these switches. This is a genuine OEM kit. Please remember to disconnect the power to your microwave before starting the repair. PLEASE NOTE: The door interlock switch kit includes 2 single pole, double throw (SPDT) micro switches. As per the manufacture for the secondary interlock switch order part # 56001100.

Magnetron

This part is used to generate microwave energy/heat.

Plate,mount

Lamp holder

This genuine OEM light socket provides power to the light bulb in your microwave while holding it in place. This light socket is two pronged and the bulb should screw easily into it. If your light bulb will not light, check the bulb itself and light socket’s connection. If the socket is broken, or faulty it should be replaced immediately. Make sure to remove the high-voltage capacitor from your microwave before beginning this repair.

Diode (cable, assembly) (cable,assembly)

High-voltage diode wire (diode assembly)

This part allows power to go only one way.

Air damper (damper)

Hardware mounting kit

Cabinet screw (screw)

This screw is sold individually.

Spring

Tape,sealing

Thermostat