UPGT650EHMG GE Dryer Parts List

Parts assembly, svc (2 pack) (dryer drum roller. If the dryer is noisy the roller may be worn and requires replacement. The bearing in the roller is self-lubricating so no grease i)

The drum support roller for your dryer holds the drum in place while the drum turns on the support wheels. The drum roller is round with a bearing in the middle and measures approximately 3 inches in diameter. If the dryer is noisy, won’t tumble, or takes too long to dry, you might need to replace the support roller. It is recommended that you replace both rollers at once. The bearing inside this roller is self-lubricating, so no grease will be required. Please remember to disconnect the power to your appliance before starting your repair. This is a genuine OEM part.

Thermal fuse (dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't Star)

The high limit thermostat protects the dryer by shutting off the heating element when the dryer overheats. If the thermostat has blown, dryer won’t start or there is no heat, the thermostat will need to be replaced it can not be reset. If your dryer vent is clogged it could cause the thermostat to blow as well. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Dryer drum belt (dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves.)

The drive belt is made to wrap around the drum, working with the tension pulley to rotate the drum. If your dryer drum will not turn, then you may need to replace your belt. This drive belt is 1/4-inch wide with 4 ribs and 3 grooves. It is recommended to disconnect the power to your dryer before you start your repair. This drive belt is a genuine OEM part.

Moisture sensor (dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic dryi)

The moisture sensor, also known as a humidity sensor, works in conjunction with your dryer by helping determine the amount of moisture in the drum to reduce overdrying. If the timer doesn’t advance correctly, it is suggested to check the moisture sensor bar for damage. A damaged sensor can cause the automatic drying cycle to not work properly and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting this repair.

Heating element assembly (dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause.)

They are all strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer

Thermostat assembly (dryer high-limit thermostat. L257-88f, l125-31c. The high-limit thermostat cuts off power to the dryer if the dryer overheats.)

The high limit thermostat on your dyer prevents your dryer from overheating. When the dryer heats up too much, the high limit thermostat will sense it and automatically shut off the heating element. If the thermostat is malfunctioning, it will need to be replaced, to avoid more serious issues. This product is an OEM part, direct from the manufacturer.

Felt seal (felt seal, dryer drum)

Drive motor (dryer drum drive motor with pulley. If the dryer does not start the motor could be bad.)

This motor works with the belt to drive your dryer's drum.

Pulley,idle (idler pulley wheel with bearing)

Switch assembly,safety

Blower wheel

Micro switch (micro switch assembly. Switch is two terminal normally closed.)

Also known as a belt switch.

Duct assembly (dryer discharge duct assembly)

Duct assembly

Tub,drum(rear)