WBSR3140GW GE Washer Parts List

Water level pressure switch (pressure switch for water fill level)

This switch keeps your washer from overflowing. It is responsible for shutting off the power to the fill valve and redirects the power to the timer to start the washing machine running once the correct water level has been reached.

Rod and spring assembly Green (suspension rod and spring assembly, Green)

This part helps center and support the drum, transmission and motor assembly.

Drive motor and inverter assembly (motor and inverter assembly)

In the spin cycle the drive motor rotates the spin basket. When its in the agitation cycle it turns the gearcase shaft. Note: Please unplug the washer before installation.

Screw - 1/4-20 mch hxw 5/8 s (scr 1/4-20 mch hxw 5/8 s)

This is a replacement screw for your washer. The screw has a hex head and is approximately 1 inch in length. The washer portion of this screw is approximately 1 inch in diameter. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Timer (washing machine timer assembly, quick connect.)

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Triple water inlet valve (triple water valve)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Screw - black (screw 8-18 ab ihwp 7/8 s)

This screw is sold individually.

Outer tub (washing machine outer tub. *for tub bearing see related items.)

This part holds the water during the wash cycle and houses the spin basket.

Tub cover - white (upper outer tub cover)

This cover goes on top of the balance ring that is located on top of the basket.

Top panel - white (top panel)

Locking clip

Sold individually.

Hinge bushing

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)

Belt installation tool (service kit belt tool)

This part is the replacement belt install tool for your dryer. It comes with two round plastic halves of the tool that are held together with an o-ring (also included). To use the tool, position the two halves of the tool together, and roll the o-ring into the groove to secure. The belt install tool will allow you to replace a damaged drive belt on your dryer. Be sure to disconnect power to the dryer before you begin this repair. This is an OEM part sourced directly from the manufacturer.