WBXR1060T0AA GE Washer Parts List

Hub washer

This is a replacement hub washer for your washing machine. If your washer is noisy, leaking, shaking, or pumping without spinning, you may need to replace the hub washer. The hub washer is found under the washer tub, beneath the split ring. You will need to remove the tub to access it. Before doing so you should disconnect the power and water sources from washer. The washer is made of metal and is a little more than an inch in diameter. It is sold individually, and is an OEM part.

Pump to tub inlet drain hose (hose from outer tub to the drain pump)

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

Water pressure switch hose (pressure switch hose)

This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, so the switch can control how much water enters the washer during a cycle. If your washer will not fill up with water, or if water continues to fill the tub even after it is full, you may have a damaged water pressure switch hose. Inspect the hose for cracks and leaks, and if the hose is damaged you will need to replace it.

Water level pressure switch (pressure switch for water fill level)

This switch keeps your washer from overflowing. It is responsible for shutting off the power to the fill valve and redirects the power to the timer to start the washing machine running once the correct water level has been reached.

Temperature switch - 3 position (water temperature selector switch)

Also known as a Rotary Switch. This part regulates the temperature of the water in the tub.

Transmission and brake assembly (transmission and brake assembly, includes new tub seal)

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

Agitator (agitator assembly)

This part does not include the agitator cap. Must order separately.

Clutch and retaining clip (washing machine clutch assembly with retaining clip.)

This part is used with units that have a removable front panel.

Leveling leg (leg leveling)

Sold Individually.

Locking clip

Sold individually.

Lid switch actuator

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Hinge bushing

Timer (timer assembly, 1 ea.)

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)