WDSR4110T0AA GE Washer Parts List

Drain hose clip (mounting clip for washing machine drain hose.)

This clip holds the drain hose to the back of the washer.

Hub washer

This is a replacement hub washer for your washing machine. If your washer is noisy, leaking, shaking, or pumping without spinning, you may need to replace the hub washer. The hub washer is found under the washer tub, beneath the split ring. You will need to remove the tub to access it. Before doing so you should disconnect the power and water sources from washer. The washer is made of metal and is a little more than an inch in diameter. It is sold individually, and is an OEM part.

Pump to tub inlet drain hose (hose from outer tub to the drain pump)

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

Water pressure switch hose (pressure switch hose)

This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, so the switch can control how much water enters the washer during a cycle. If your washer will not fill up with water, or if water continues to fill the tub even after it is full, you may have a damaged water pressure switch hose. Inspect the hose for cracks and leaks, and if the hose is damaged you will need to replace it.

Fabric softener dispenser (fabric softener dispenser for top of agitator)

This part is a replacement fabric softener dispenser for your washer. If your washer will not dispense fabric softener or detergent, or will not agitate, you may need to replace the dispenser. When it is working, the dispenser releases fabric softener during the wash cycle. You can find the dispenser screwed in to the top of the agitator. To replace the dispenser simply unscrew it, and replace it with a new one. This is an OEM part, and is sold individually.

Transmission and brake assembly (transmission and brake assembly, includes new tub seal)

This transmission and brake assembly comes with a new tub seal. This kit aids in the spinning or agitating cycles.

Clutch and retaining clip (washing machine clutch assembly with retaining clip.)

This part is used with units that have a removable front panel.

Leveling leg (leg leveling)

Sold Individually.

Locking clip

Sold individually.

Hinge bushing

Lid switch actuator

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)

Anti-siphon clip (anti-sipohn hose clip)

This part helps prevent the backflow of water from the tub to main water line.

Drain hose - pump to cabinet (drain hose, pump to cabinet)