WHDSR315DW GE Washer Parts List

Tub cover - white (upper outer tub cover)

This cover goes on top of the balance ring that is located on top of the basket.

Top panel - white (top panel)

Water level pressure switch

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Leveling leg (leg leveling)

Sold Individually.

Lid switch assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

Capacitor

This part increases the voltage to the drive motor to help start it.

Locking clip

Sold individually.

Hinge bushing

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)

Washer timer (timer)

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Anti-siphon clip (anti-sipohn hose clip)

This part helps prevent the backflow of water from the tub to main water line.

Hose clamp kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Hinge bushing

Screw (screw 14-10 a trt 7/8 s)

This screw is sold individually. Size: 14-10 a trt 7/8 s.