WJRR4170EW GE Washer Parts List

Leveling leg (leg leveling)

Sold Individually.

Triple water valve (valve triple water)

This triple water inlet valve is a genuine OEM replacement part for your washing machine. This inlet valve helps fill the washer with water during the wash cycle. If the machine is not filling or taking too long to fill, the inlet valve may need to be replaced. If you are not sure if the inlet valve is faulty, you can test it for continuity using a multimeter.

Capacitor

This part increases the voltage to the drive motor to help start it.

Lid switch assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

Locking clip

Sold individually.

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)

Anti-siphon clip (anti-sipohn hose clip)

This part helps prevent the backflow of water from the tub to main water line.

Hose clamp kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Drain hose - pump to cabinet (drain hose, pump to cabinet)

Screw

Sold individually.

Scr 8-18 b ihw 1 s (screw 8-18 b)

Timer (timer asm washer)

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Lid bumper (bumper lid)

This bumper is sold individually. The bumper is located under the washer lid.

Screw-pkg 12 (screw, pack of 12)