WM Parts List

R ceramic fuse,20a/250v,mhc (fuse)

Rotor assembly (wm-motor)

This rotor assembly is a manufacturer-approved replacement part for your washing machine. The rotor is an important part to rotate the tub during the wash cycle. It can need replacing if the magnets or splines become damaged. Unplug the washer before beginning this repair. To complete this repair, you will need a Phillips screwdriver, a 17mm socket wrench, and thread-locking fluid.

Drive coupling (driver, turntable)

This glass tray drive coupling, also known as a tray support, is a genuine OEM replacement part. It can help solve the issue of your microwave tray not turning properly. This motor couple connects the motor to the turntable. To replace this part, make sure the microwave is unplugged first. Remove the glass tray, and the existing coupling. Insert the new coupling into the motor shaft.

Drive coupling (turntable drive coupling)

This part has a D-shaft for the motor shaft.

Vent grille - stainless steel (grill-vent)

This is replacement vent grille for your microwave. You will find the grill vent either above or below the microwave door, depending on your model. If your microwave vent grill is discolored or cracked, or if the mounting brackets for the grill are broken, you may need to replace it. You will need a Phillips-head screwdriver to detach the vent grill from the microwave. This part is made of stainless steel and is approximately 30 inches wide and 4 inches tall. This product is sold individually.

Shaft and mode shifter assembly (shaft & mode shifter asm)

Also known as the gearcase or transmission. This part helps move the agitator back and forth during the wash cycle. New shifter mounting holes are NOT threaded, use original self tapping screws to install new part. Tub seal is included with assembly.

Shock absorber kit (parts assembly)

This kit includes 1 shock absorber and 2 mounting pins.

Socket rod support - white (washer suspension rod socket)

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the rod can prevent the tub from shaking too much during operation. If your washer is shaking excessively or emitting an odd sound during use, it may be because the rod support is broken, and the suspension rod is not able to do its job. This part is made of white plastic and is sold individually.

Spider

The spider, or rear tub support, is located behind the outer tub of your washer, and provides support to the outer tub. It has 3 legs and each measures approximately 10 inches long. If your washer moves or shakes, or sounds noisier than usual during the washing cycle, the support spider may be faulty or broken and should be replaced immediately.

Water level pressure switch (switch pressure)

This switch keeps your washer from overflowing. It is responsible for shutting off the power to the fill valve and redirects the power to the timer to start the washing machine running once the correct water level has been reached.

Meal rack and supports (use wpl w10315274)

This rack includes the 4 supports.

Oven rack (rack, oven)

Sold individually.

Inlet valve assembly (valve assembly,inlet)

This valve is used for cold water, bleach dispenser and prewash cycles. It has a standard hose fitting inlet with 2 outlets facing 45 degrees to the right and one outlet facing 45 degrees to the left.

Gasket

This genuine OEM drum seal gasket prevents water from leaking between the outer tub and spin basket of your washer. It is made of black rubber and measures 2.5 inches in diameter. If your washer is leaking, and running noisier than usual, check for wear on the gasket, and to ensure it is properly fitted.

Bake element (element, bake)

This bake element is found on the bottom of the oven.