YFD45GSPM1DG GE Dryer Parts List

Drive belt (belt drive)

This dryer drum drive belt is 89.5" long and has four ribs. This part helps spin the drum during the drying cycle.

Duct felt seal (felt trap duct)

The duct felt seal allows the front of the drum to glide smoothly on the exterior panel while the drum is rotating. The seal is located between the back of the drum and the rear dryer panel. If the heat is escaping from the drum area causing the dryer to run too long or if there are marks on your clothes you many need to replace the duct felt seal. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Light bulb (lamp)

This 10W - 120V light bulb is used on the inside of your dryer to provide light when the door is open. It is clear in color and has a standard screw-in base. If your current bulb is burnt out or broken you will need to replace it. This bulb is a genuine OEM part and is sold individually.

Drum bearing sleeve (sleeve drum)

Sold individually.

Dryer bearing slide 2-pack (bearing slide)

Drum glide bearing - white (sold individually) (bearing slide)

Door latch (latch)

This part helps to keep the door closed while the machine is running.

Door switch

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Adjustable leveling screw (levelling screw gray)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Nut (cap nut)

Inlet control thermostat

This part is located on the housing for the heating element.

Complete duct trap assembly (trap duct / front seal)

Natural gas to liquid propane conversion kit (lp conversion kit)

This conversion kit changes the dryer from natural gas to liquid propane. Installation instructions are included.

Heat detector (detector asm)

Also known as Flame Sensor/Detector.

Strike plate w/strk hole