Whirlpool Dishwasher Parts
Find Your Appliance Parts

Search by part or model number

Need help finding your Model Number?

Why do we need your model number?

Every model has its own, specific solutions. If you go to a car mechanic they'll need to know the exact make and model of your car to find the right repair parts. Appliances are the same. See this guide for help.

Whirlpool Dishwasher Parts

Dishwasher Heating Element

(3)

Part Number: W10518394

The heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dishes are not drying or the water in the dishwasher is not getting hot you may need to replace the element. This kit includes the heater, two heater fasteners, and is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Easy Part #:

EAP8260087

Availability:

In Stock

Your price

$31.90

Rack Track Stop

Part Number: WP8565925

This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11746591

Availability:

In Stock

Your price

$6.09

Dishwasher Lower Dishrack Wheel Assembly - Gray

(15)

Part Number: W10195416V

This is an authentic OEM replacement part that has been sourced directly from the manufacturer and is designed for use with a variety of dishwashers manufactured by KitchenAid, Whirlpool, Maytag, Kenmore, Jenn-Air, and Amana. For full compatibility, please see the "Model Cross Reference List" below. The purpose of this part is to allow the lower dishrack to roll back and forth on the rails easily. If your dishrack no longer glides smoothly, or if your Wheel Assembly is visibly damaged, it needs to be replaced. Each Assembly is sold individually (to replace both sides, you will need to order two assemblies)

Easy Part #:

EAP11722152

Availability:

In Stock

Your price

$22.78

Rubber Washer

Part Number: WP717273

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Easy Part #:

EAP11743934

Availability:

In Stock

Your price

$4.98

Mounting Bracket

(1)

Part Number: WP8269145

The mounting bracket is used to attach the dishwasher to the underside of the counter. The mounting bracket holds the dishwasher in place to keep it from moving during cycles and to keep the dishwasher level. The bracket is made of metal and is approximately 3” in length. The screws are not included with the bracket, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the dishwasher before starting the repair.

Easy Part #:

EAP11745496

Availability:

In Stock

Your price

$7.61

Friction Sleeve

Part Number: WP8268961

The friction sleeve helps to reduce friction between the door hinge and the door and to keep your door quiet when it opens and closes. This part is a little over an inch long and is black in color. It is sold individually.

Easy Part #:

EAP11745488

Availability:

In Stock

Your price

$5.91

Dishwasher Door Gasket with Strike - Black

(1)

Part Number: W10542314

This one-piece door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking, tears, or there are gaps in your gasket, you may need to replace the door gasket. This black door gasket is made of rubber, includes a new latch strike plate for the door latch, and is a genuine OEM part.

Easy Part #:

EAP5136129

Availability:

In Stock

Your price

$52.98

Dishwasher Drain Pump

Part Number: WPW10348269

This drain pump (120V 60Hz) is used in dishwashers to remove water from the dishwasher tub. If the impeller in the dishwasher is damaged or the motor has been shorted out and will not drain, it is possible the body is cracked, causing leakage. To prevent this from happening, replace the drain pump. The tools needed for this installation are: Phillips screwdriver, 5/16 inch nut driver, 5/8 inch wrench, and a flathead screwdriver. Remember to unplug your dishwasher from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions.

Easy Part #:

EAP11753379

Availability:

In Stock

Your price

$55.72

Hose Clamp

Part Number: WP596669

This washing machine hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Easy Part #:

EAP11743008

Availability:

In Stock

Your price

$5.28

Chopper Assembly

(2)

Part Number: W10083957V

This part chops up/mince the food particles to prevent from clogging the dishwasher pump.

Easy Part #:

EAP11722146

Availability:

In Stock

Your price

$19.25