48842 LG Parts List

Bolt assembly

Clamp

The hose clamp works in conjunction with the water hose in the appliance by holding the water hose in place to keep the hose from leaking water on to the floor. If you notice your appliance leaking, you may have a crack in the hose or that the clamp is loose and will need to be replaced. The hose clamp is made of metal, measures approximately 1/2” in diameter and sold individually. This is a genuine OEM part.

Bolt assembly

Pump casing

This part connects to the drain pump and motor.

Tapping screw

This metal tapping screw is for washers (exact placement depends on model), it measures 0.5 inches (length) by 0.25 inches (width). This screw is sold individually and requires a Phillips head screwdriver to install.

Clamp assembly

Bolt assembly

Door boot seal - with drain port (door boot gasket with drain port)

Also known as a bellow.

Washer motor rotor position sensor (rotor position sensor (rps))

The sensor monitors the direction and speed of the spinning rotor.

Hose,connector

This part is the replacement connector hose or clean-out drain hose for your washer. It is black in color and is sold individually. The connector hose drains water out of the washer if the drain cycle is not working. If the hose breaks, it will not be able to drain the water properly, and you may experience a water leak. Be sure to disconnect your washer from the power source, as well as the water source before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Hose (bellows)

Holder

Bolt,common

Float assembly

Screw,customized