8MSF25N4BW00 Refrigerator Parts List

Led light control board (refrigerator light board)

Installation screw (refrigerator door closer cam screw)

This screw is sold individually.

Set screw - door handle (refrigerator screw)

This screw is for refrigerators. Follow appropriate safety practices when installing screw

Freezer door gasket - white (refrigerator freezer door gasket)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Evaporator drip tray (refrigerator drain pan)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Fan grommet (refrigerator door hinge bushing)

Sold Individually - Appliance originally takes 2.

Led light (refrigerator light board)

Electronic defrost control board with wire harness and screws (refrigerator adaptive defrost control board)

This part is located in the control box in the refrigerator.

Inlet hose washer

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Bottom kickplate clip (refrigerator toe grille clip)

This clip is sold individually.

Heater, defrost (refrigerator defrost heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Condenser fan motor (refrigerator condenser fan motor)

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fan motor has 3 terminals please order part number W10204250, otherwise order this part (WP2188874).

Roller-cab (refrigerator roller)

Sold individually.

Capacitor (refrigerator run capacitor)

Axle (refrigerator roller wheel axle pin)

Sold individually.