Parts for Kenmore Models DBLR453GT0WW

M series new style coil kit

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:: EAP334310

Availability:: In Stock

Price:: $26.40

D-shaped knob clip (u clip)

This control knob clip helps secure the timer knob to the shaft allowing you to select the desired setting for your dryer. If the knob has become loose or the clip is missing you will need to replace the clip. This clip is a genuine OEM part, made of metal and is sold individually.

Easy Part #:: EAP268493

Availability:: No Longer Available

Rear drum bearing kit (shaft & bracket asm)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Easy Part #:: EAP267529

Availability:: In Stock

Price:: $62.96

Selector knob with clip (knob & clip asm wh)

This knob accepts a D-shaped shaft. Sold individually.

Easy Part #:: EAP271094

Availability:: In Stock

Price:: $14.28

Drive belt (belt drive)

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

Easy Part #:: EAP2350043

Availability:: In Stock

Price:: $25.19

Drum slide (bearing, slide)

This slide is sold individually. Some dryers require up to three of these slides . Be sure to check to make sure you order the necessary amount for your dryer.

Easy Part #:: EAP267877

Availability:: In Stock

Price:: $12.91

Door handle - white (handle door wh)

This part is on the outer door of the dryer.

Easy Part #:: EAP9494490

Availability:: In Stock

Price:: $23.34

Idler pulley wheel (pulley idler)

The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Easy Part #:: EAP265721

Availability:: In Stock

Price:: $28.58

Rotary start switch

This part is used to start the dryer once you have selected a setting on the timer.

Easy Part #:: EAP268305

Availability:: In Stock

Price:: $50.36

Lint filter with frame

This part may differ in appearance, but functions same as original.

Easy Part #:: EAP266269

Availability:: In Stock

Price:: $60.32

Timer knob (knob, timer wh)

This is a timer knob for your dryer. It is found on the control panel and allows you to turn your dryer on and adjust the settings. If the timer will not advance, or you notice the knob is damaged, you will need to replace it. This timer knob is white in color with a small red arrow printed on it, and is made of plastic. It is sold individually and is a genuine OEM part from the manufacturer.