DBXR463EGW GE Dryer Parts List

Cycling thermostat - 4 wire (cycling thermostat with bias heater, l210-30f)

This thermostat helps to regulate the dryer's internal temperature. L210-30F

Adjustable leveling screw (leveling leg, adjustable)

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able to create a level base for your dryer. The leveling screw has a hexagon-shaped gray plastic foot, with a screw that is approximately 1 inch in length. To replace a damaged screw, simply turn the old screw to the left, until it can be removed. Then, simply screw the new leveling screw into place on the bottom of the dryer, making sure it is the same height as the other 3 leveling screws.

Nut (cap nut)

High limit thermostat - l315-65 (high-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element.)

This part is the replacement high-limit thermostat or safety thermostat for your dryer. The high-limit thermostat is found on the upper right-hand side of the heater housing, and it cuts off power to the dryer motor if the temperature reaches an unsafe level. If you push the start button and nothing happens, the high-limit thermostat should be tested for continuity and replaced if the contacts are open. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an OEM part.

Drive motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Blower wheel (blower wheel for dryer)

This wheel attaches to the motor.

Screw

Terminal block and grounding strap (terminal block and grounding strap for power cord)

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

Cycling thermostat (cycling thermostat with bias heater. On blower housing.)

This thermostat is located on the blower wheel.

Timer resistor

Screw

This screw is sold individually. Size: 10-16x1/2

Drum baffle

This is the replacement drum baffle for your dryer. It is made of black plastic and is approximately 14 inches by 4 inches. This part is sold individually and is an OEM part sourced directly from the manufacturer. The drum baffle is found inside the dryer drum, and it helps tumble your clothes. If the baffle is damaged or missing, you may notice marks being left on your clothes. The main reason you would replace the baffle is if you notice these marks, if the baffle is broken, or keeps falling off.

Door hinge (dryer door hinge)

Screws NOT included.

Screw #10

Idler spring arm (idler arm)

This part, along with the idler pulley wheel, helps the belt to rotate the drum.