EF48DBSS Dacor Refrigerator Parts List

Flipper

This part is a replacement flipper or emitter cover for your refrigerator. It is made of white plastic and is approximately 3 inches by 2 inches. The flipper shields the emitter control board and houses the flipper cover for the emitter board. If your flipper is broken or missing, your ice maker may not make or dispense ice, and will need to be replaced. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Stripper arm kit (use wpl w10297244)

This kit includes the stripper arm and fill cup.

Cycling thermostat (use wpl 627985)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Coupling (coupling, top)

Sold individually.

Screw

Sold individually.

Levers retainer/clip

This part is the replacement dispenser lever retainer for your refrigerator. It is made of metal and is approximately 2 inches long and ½ an inch wide. The bottom half of the dispenser lever retainer holds in the pivot points of the ice and water arms. If it breaks, the arms will be loose and can shake around. The top half springs the ice and water arms back into the original position, and if the retainer is broken, they will not be able to do this. The dispenser lever retainer is found behind the dispenser trim and can be removed with a ¼ inch nut driver. This part is sold individually and is an OEM part.

Light socket kit (use wpl 4387478)

The bulb is sold separately.

Washer, coupling (coupling washer)

This washer is sold individually.

Ice maker cover bracket (icemaker cover bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Auger motor - 120v 60 hz. (dispenser, motor)

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

Cntrl-elec (use wpl 4389102)

This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker when to refill with water.

Dispenser grille

This black dispenser grille catches any overflow from the ice/water dispenser.

Dispenser door pin

This dispenser door pin comes with the washer.

Drive shaft coupling sleeve (sleeve, coupling)

Sold individually.

Door bin assembly (bin-cntlvr)