F12A1FD LG Washer Parts List

Spring,hinge

Bolt assembly (washing machine shipping bolt assembly, long. Shipping bolts are installed to secure the washer tub during transportation.)

Clamp assembly (washing machine door boot clamp for front panel.)

The door boot seal clamp, also referred to as an outer door gasket clamp, holds the door boot in place in a front-loading washer. If your washer is leaking from the door and there are no signs of damage to the door boot seal, check to ensure that it is securely fastened. If your boot seal clamp is faulty, or damaged, it should be replaced immediately.

Bolt assembly (washing machine short shipping bolt assembly.)

Pump filter (washing machine filter and trap assembly.)

This replacement pump filter, also known as a filter assembly, is a genuine OEM part for your washer or washer/dryer combo. Before beginning this repair, turn off the power and water supply to your washer. The filter assembly may need to be replaced because it is broken or is leaking water. To locate the filter assembly, pry open the small door on the front of the washer, using a flat-blade screwdriver. Unplug the drain hose next to the filter and drain the water into a bucket. Then unscrew the pump filter, and replace with your new one.

Hinge assembly

The door hinge attaches the door to the front panel of the washer cabinet. If the door hinge is damaged, or faulty, the door may not close or open properly and can lead to the unit leaking during the wash cycle. This genuine OEM part is sourced directly from the manufacturer, made of stainless steel, and measures approximately 12 inches long x 6 inches wide.

Leg assembly

This levelling leg is a genuine replacement part. It is used to help keep your washing machine stable and balanced. It helps support your appliance. It screws into the base of your washer, and you can thread it in or out to adjust the height. The foot on this leg is made of rubber, which helps with grip, stabilization, and vibration reduction. It is also hexagonal in shape, which allows you to more easily adjust it. This levelling leg features a locknut on the shaft which can be tightened against the bottom of your appliance, this will stop the leg from rotating while you are using your washer. This replacement is sold individually.

Lifter assembly

Clamp assembly

Hinge

The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.

Rotor assembly

Spring,hinge (spring hinge)

this is an individual part and does not come as a set

Switch assembly,pressure

Hose,inlet

Hose (bellows)