LA710S Maytag Washer Parts List

Siphon break connector kit (siphon break connector with clamp)

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.

Syphon break elbow kit with clamp (siphon break elbow kit with clamp)

For drain hose 7/8".

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Screen (inlet screen, water valve)

Found on the water inlet valve.

Damper pad kit (damper pad kit for base support with lubricant, also order rcc #1243096, rubber adhesive)

This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place.

Screw

Sold Individually.

Glide and spring kit (washing machine motor slide-plate repair kit)

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Inlet hose - 5 ft (5-foot-long rubber fill hose for washing machines. Used for hot or cold water.)

This hose can handle hot or cold water and is five feet long.

Brake assembly (brake assembly Maytag 2 belt washer)

The brake assembly aids in the spinning or agitating cycles. The brake keeps the spin basket stationary during agitation while the basket stops at the end of the spin cycle. If your washer is making a loud squeaky sound or not spinning, you might need to replace the brake assembly. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to your appliance before starting your repair.

Injector hose seal - seal no longer includes hose (injector hose located at top of tub cover)

This Injector hose seal is sold individually. The injector hose is no longer available.

Rear bearing (break bearing above brake assembly. Maytag two belt washer.)

This part is located near the tub's brake assembly.

Hose washer and screen insert kit (hose washer and filter for washer inlet hose)

The hose washer in this washer and screen insert kit is an inch in diameter. The insert is all blue in color and is made entirely of plastic, while the washer is all black in color and made entirely of rubber.

Air tube for tub fill volume (washing machine air tube for tub fill volume)

Injector hose

This washing machine injector hose runs from your washer's inlet to its injector. It is black and made of rubber. It is also available in an injector kit.