PCF25MGWC GE Refrigerator Parts List

Screw - 12-24 tt ovt .900 s (screw)

Sold individually.

Micro switch (switch)

This is the replacement micro switch, or dispenser switch for your refrigerator. It is gray in color and measures approximately 1 inch by half an inch. The dispenser switch is what tells your refrigerator that it is ok to dispense ice or water. If your refrigerator is not dispensing ice or water, you may have a faulty or damaged switch. Be sure to disconnect the power to your refrigerator before you begin this repair. This switch is sold individually and is a genuine OEM replacement part sourced directly from the manufacturer.

Water filter (water filter cartridge)

This OEM water filter works with side-by-side and bottom freezer refrigerators. You will find this filter mounted in a vertical position in the back upper right-hand corner of the refrigerator compartment. If your model does not have an indicator light, remember to use the month and year stickers on the new cartridge to remind yourself to replace it in another 6 months. Replacement timelines can vary according to your local water conditions. To install the new filter, you will first match the threads with the corresponding threads on the holder. Position the top of the new cartridge up into the holder without pushing it upward. Carefully turn it to the right until it will no longer turn. Make sure you run water through the dispenser right after installation. This clears the system and prevents sputtering. If you have an LCD model, press the Filter Replaced button to reset. If you have a non-LCD model, press and hold the Reset Water Filter button on the dispenser for a few seconds. This filter filters down to 0.5-1 microns. The lower the micron the more toxins are caught and lessened.

Water valve

This part releases water from the supply line when it's activated.

Evaporator drip pan (trough drain asm)

This is the replacement evaporator drip pan, also known as the drain trough, for your refrigerator. You will find the drip pan in the fresh food section of the refrigerator. It collects any water that may drip off the evaporator. If your drip pan is rusted, or is leaking into the refrigerator, you may need to replace it. Before you install the new drip pan, you will want to thoroughly clean the areas around the evaporator to ensure there is no more remaining rust or debris. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Grommet / tube assembly (grommet and tube asm)

This is a replacement fill tube and grommet assembly for your refrigerator. This part acts your water line to your ice maker. If you’re noticing water in the back of the refrigerator or any kind of leak, or if your ice bucket isn’t filling up with as much ice, you may need to change out the fill tube and grommet assembly. When you purchase this part, you get the water line, as well as the fill tube and grommet. This is an OEM part sourced directly from the manufacturer.

Bucket glide - left side (glide bucket lh)

This is a replacement bucket glide for your refrigerator. The ice bucket rests on the bucket glide, which allows it to slide in and out when you want to access the ice bucket. If the glide is broken, you will notice that your ice bucket is hanging to one side, or that it will not slide back into place and remain there. To replace the bucket glide, remove the ice bucket and then unscrew the bucket glide from the refrigerator wall. You will find a bucket glide on either side of the ice bucket, but this part is for the left side only. Be sure to check which bucket glide you need before you replace it. This part is sold individually.

Armature kit (shroud solenoid)

Housing crusher dispenser (housing crusher disp)

Screw

Size: 10-32 GXTT FLP .595 Sold individually.

Middle chiller drawer (pan middle chill asm)

This part is the replacement middle chiller drawer for your refrigerator. It is made of clear plastic, with a white plastic front frame, and is approximately 16 inches deep, 21 inches wide, and 13 inches tall. The chiller drawer rests in the middle of your refrigerator, and slides in and out to allow you to store items. The main reason to replace this part is if the old drawer is cracked, broken, or missing. To replace the drawer, simply remove the old drawer and replace it with the new one. This is an OEM part and is sold individually.

Shelf support

Sold individually.

Switch light fz (switch light)

3 terminal.

Screw - 10-16 (scr 10-16)

Freezer shelf trim - white (trim shelf fz)

TRIM SHELF FZ