PDW8500JB GE Dishwasher Parts List

Heating element (element heating assy)

Drain pump (drain pump assembly)

The drain pump ejects the water from the dishwasher.

Comb retainer (retainer comb)

Retainer handle - black (retainer handle)

This part is the replacement retainer handle for your dishwasher. It is made of black plastic and is approximately 5 ½ inches long and 2 inches wide. The handle retainer attaches to the handle of your dishwasher and holds the door closed during operation. If your dishwasher experiences a door latch failure, you may need to replace the retainer handle. Be sure to disconnect your dishwasher from the power source before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Sump filter and cover (sump filter and cover assembly)

This works in conjunction with the pump and filtration system. It is used to filter the drainage for disposal.

Lower rack comb (comb lower rack asm)

Screw 8-32 b hxw 1.13 stainless steel (screw 8-32 b hxw 1.13 ss)

This upper spray arm screw is a manufacturer-approved replacement part for your dishwasher. The spray arm is an integral part of the dishwashing process, so keeping it maintained is crucial. To replace this screw, remove the upper dishrack by popping out the dishrack stops on each side. Pull out the dishrack and use a 1/4 inch nut driver to unscrew the upper spray arm screw.

Upper spray arm (upper wash arm assembly)

This part is the upper spray arm for your dishwasher. It is made of gray plastic and is approximately 11 inches wide. The upper spray arm is mounted to the top of the dishwasher tub and rotates during the cycle to ensure that your dishes are washed evenly. If your spray arm is clogged or damaged, your dishes may not clean evenly, and you will need to replace the spray arm. To access the spray arm, you will need to remove the top dish rack, then simply unscrew the old arm. Screw the replacement arm in and replace the dish rack to complete the repair.

Flood switch (switch flood asm)

Lower rack comb (lower dishrack comb assembly)

Hose clamp kit

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Leveling leg

This leveling leg is located under the dishwasher cabinet. It is sold individually.

Water inlet valve

May look different than the original, but will function the same.

Washer

Scr 8-10 pl trp 1/2 s (screw)