RSD Parts List

Bake element (13.5" long x 18.5" wide) (bake element)

The bake element is located on the bottom of the oven and supplies heat for baking. This part measures 13 1/2-inch long, 18 1/2-inch wide with the depth of the terminals is 3-inch. If your oven is too hot, not heating evenly, the element is not heating, or there is little to no heat when baking you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.

Hinge kit - right side (kit, door hinge (rh-s)

The oven door hinge assembly attaches to the right side of the door allowing the oven door to open, close, and stay open at an angle. If your oven door is not working properly then you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures approximately 11 1/2” long, is made of metal, includes a spring and two screws. This is a genuine OEM part.

Svc hinge kit (oven door hinge kit. Two hinges in kit. For ss models)

Plastic tubing (sub 67579-25)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Screw - 6-32 x 5/16 (sub 74004005)

This screw is well under an inch long, and is made of metal.

Hinge kit - left side (kit, door hinge(lh-hs)

The oven door hinge kit attaches to the left side of the door to help control the opening and closing of the oven door. The door hinge also allows the oven door to stay open. The door hinge kit includes the left side hinge, screws and the spring. This hinge measures approximately 11 1/2” long and is made of metal. The manufacturer suggests using the pointed screw to cut threads in the new hinge holes.

Ice maker front cover (cover ice maker)

Screw

Sold individually.

Refrigerator compressor start relay (sub 10097202)

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.

Leveler (sub 68664-1)

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Screw (sub 61002180)

This screw is less than an inch long, and is made entirely of metal. Sold individually.

Light blub - fluorescent - 18 watt (lamp, fluorescent)

This light bulb is used in a range's control panel.

Bowl-drip (burner bowl, square)

This single square chrome drip pan has sides measuring just about eight inches. Its center hole has a diameter of just over four inches wide. Use this drip pan for your Amana brand gas range. Sold individually.

Refrigerator defrost heater kit (sub 61001874)

There are two defrost heaters in this kit. Each is twelve inches long.

Defrost evaporator pan

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.