WDSR2080DC GE Washer Parts List

Outer tub (tub asm x-large)

This part holds the water during the wash cycle and houses the spin basket.

Agitator (agitator asm straight)

This part does not include the agitator cap. Must order separately.

Tub cover - white (cover tub)

This cover goes on top of the balance ring that is located on top of the basket.

Top panel - white (cover asm finished)

Leveling leg (leg leveling)

Sold Individually.

Timer (timer asm washer)

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Locking clip (clip locking)

Sold individually.

Hinge bushing (bushing hinge-front open)

Water fill nozzle (hose and water inlet)

This part is the replacement water fill nozzle for your washer. It is white and tan in color, made of plastic, and is approximately 7 inches long and 4 inches wide. The water fill nozzle is also known as the water inlet assembly and directs the fill water into the tub. Over time the nozzle can become cracked and damaged, and this can cause it to leak. A damaged nozzle will need to be replaced. Be sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, including the water inlet hose, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Washer lid (lid asm finished)

The lid covers the washer tub opening.

Screw 10-18 pl (screw)

Sold individually.

Drain hose extension with adapter and clamp (drain hose extension kit with hose inserts and clamps)

Magnet assembly (magnet asm)

Screws - package of 12 (scr 8-18 b hxw 1/4 s)

These are replacement screws designed to fit your range. They are made of metal and are approximately ¼ inch long. They come in a package of 12. These are OEM parts sourced directly from the manufacturer.

Belt installation tool

This part is the replacement belt install tool for your dryer. It comes with two round plastic halves of the tool that are held together with an o-ring (also included). To use the tool, position the two halves of the tool together, and roll the o-ring into the groove to secure. The belt install tool will allow you to replace a damaged drive belt on your dryer. Be sure to disconnect power to the dryer before you begin this repair. This is an OEM part sourced directly from the manufacturer.