NA Parts List

Brake pad kit

This brake pad kit contains three brake pads and six installation screws. Helps to bring a rotating cycle to a stop.

Screw with washer (agitator retention screw)

Sold individually.

Suspension spring hook (hook, suspension spring)

Ring-o (o ring)

Agitator top

This part fits on top of the agitator base.

Idler pulley spring (idler spring)

This idler pulley spring is made of metal.

Upper spin bearing washer (washer, spin bearing, upper)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.

Agitator base (base, agitator)

Base only. Top agitator sold separately.

Tub to housing gasket (gasket - tub to housing)

This gasket is intended to fit between the washer tub and machine housing of washing machines.

Single washer inlet strainer (sub f270200)

Found at the end of the inlet hoses.

Lower bearing assembly (sub 12001562)

Tub/housing seal (seal, tub/housing)

Lid strike - white (washing machine lid strike/actuator)

This part is used to activate the lid switch when the lid opens/closes.

Range surface burner cap

The burner cap protects the burner head from spills and helps spread out the burner flame for even heating.

Washer brake rotor (brake rotor & lining asm)

This part aids in the spinning or agitating cycles.