NA Parts List

Dual action agitator (agitator assembly)

Tub to pump hose (hose, tub to pump)

The tub-to-pump hose is a flexible drain hose that connects the outer tub to the pump to carry the water from the tub to the drain pump. This hose is black in color, is made of plastic and measures approximately 17” long with a 1 1/2” diameter. If the hose becomes clogged, broken, or cracked, it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before you start this repair.

Tension idler pulley (washing machine belt tension pulley assembly)

This idler arm assembly comes with the pulley wheel.

Drain pump - 120v 60hz (pump assembly)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

Timer knob - light gray and white (knob, timer (blue-gray))

This is the second part of a three-part knob. The cap and the skirt are sold separately. This knob is blue and white in colour.

Screw

This screw is less than an inch long. It is a metallic screw that is used for many clothes washers. Sold individually.

Screw, 8-18 x 1/2 (sub 40064801)

This screw is sold individually.

Lid switch actuator - black (lid switch actuator)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Screw (sub 32671)

Sold Individually.

Suspension springs - kit of 6 (spring kit (6 of 35-5656))

This package contains a new set of six springs. The suspension springs in your washer connect to the bottom of tub, and help to hold it in place. If your washer tub shakes, or moves around a lot during operation, it could mean that one or more of your springs are damaged or stretched. You will need to access the bottom of the tub for this repair by removing the front (and possibly the rear) panel. You will also need a pair of locking pliers to remove the old springs and reconnect the new ones. It is recommended to apply a small amount of grease to the bottom of the new springs before you reconnect them to the washer tub.

Water inlet valve with thermistor (water valve w' thermistor)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Inlet hose washer (washer, 19/32 idx1.031)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Hub and seal kit (seal hub assembly (ht tran))

This kit prevents water from leaking around the drive shaft and down to the bottom of the tub.

Standpipe adapter (adapter, standpipe)

This part helps stop the washer from overflowing.

Triple lip seal and bearing kit (triple lip seal/bearing kit)

Please check your model# to verify this is correct for your appliance.