NA Parts List

Inlet hose - 5 ft (hose, inlet)

This hose can handle hot or cold water and is five feet long.

Motor pivot spring (spring, motor pivot)

This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Fabric softener dispenser

This fabric softener dispenser is five inches long. It is all white in color and is made of plastic. This dispenser has a diameter of five inches.

Screw - sold individually (screw,10-16 x 0.750)

Main tub bearing assembly (sub 40004201p)

This triangular main tub bearing assembly is five inches long. It is made of metal.

Agitator drive block (agitator drive block. If the drive block wears out the washers agitator will not work properly and may also make be noisy during operation.)

The agitator drive block works in conjunction with the agitator in your washing machine by rotating the agitator assembly. If your washer is noisy and not agitating, you may need to replace the drive block because it may be worn out. This part is located between the agitator and the transmission shaft, measures approximately 2” long and is made of metal. This is a genuine OEM part. Please remember to disconnect the power and water supply before beginning your repair.

Spinner support and seal kit (spinner support assy as-pk kit)

The bolt is built into the support so if the bolt is broken, you need to replace the kit.

Water inlet valve kit (sub r0131578)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Screw (sub 25-7732)

This screw is sold individually.

Hinge hole cover (cover, hinge hole (wht))

This hinge hole cover is sold individually and white in color. Two are required per appliance.

Water inlet valve (sub 35-2374n)

This valve has two ports for water to enter. It also comes with a metallic hose clamp.

Wave washer (washer, wave)

Spin bearing (upper spin bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Leveling leg and pad (foot & pad assembly)

This part includes locknut.

Complete hub and seal kit (sub r9900552)

This kit comes with hub, seal head, gasket, seal shroud, seal seat, screw, spline insert, drive bell and seal.